Airbus Drawing Services - General Information

Airbus provides its customers owners or operators with certain drawing categories, available online exclusively, thru connection to AirbusWorld web portal secure area:
Address: AirbusWorld/My Online services/ Engineering drawings

  1. Mechanical drawings (IAD – Installation Assembly Drawings)

    2. Access Airbus contractual drawing set for Structure and System Installations, assemblies and detail drawings, filtered to the customer aircraft . Scope limited to Airbus proprietary parts used on the original aircraft configuration, with access to the last drawing release. Post-delivery configuration not reflected. Additionnal drawing requirements handled on a case by case at drawing.service@airbus.com

  2. Tool Equipment Drawings (TED – Tool Equipment Drawings)

    3. Access to Airbus SAS and vendor tool drawings – non –proprietary – as referred in the TEM (Tool Equipment Manual) .Vendor Tool drawings classified as “proprietary” part in the TEM are not available .
    This application is Not granted to MRO’s and service providers.

  3. Repair drawings ('R' drawings)

    4. Are not part of the contractual drawing set; must be ordered /used in accordance with an Airbus approved document (SRM, SB, RAS ..etc). They can be ordered from the Repair Drawings module thru the dedicated order form, or by mail to the Airbus Drawing service at:
    drawing.service@airbus.com


Drawing categories below are not managed in the online service:

According to the IPC procedures, customized installation drawings are not reflected in the IPC. Although they look like installation drawings, the reference PNs (RF) ending with suffix 60 to 89, are fictitious part numbers (for reference purpose only) and are not procurable (NP).These PNs do not necessarily have any relevant connection with or to the Airbus drawing numbers used to compile the IPC itself.
In such cases, the access to the related drawing on AirbusWorld will be denied.

For identification of the applicable installation drawing, Airbus recommends :

  1. To use the drawing 'Parts Usage' data which provide the Next Higher Assy of Airbus proprietary parts. For equipments , it is recommended to start with an Airbus proprietary procurable part PN which is listed in the same IPC figure parts list.
  2. You may also try the “open search” in the drawing set starting from the IPC fictitious P/N root ( F2529*). you will then get a result list with drawing numbers and title .but warning ! the result list is not customized so you will not be able to open all the drawings , but only the ones effective for yr fleet.
  3. Alternatively you may use the DNI – Drawing Number index – which provides the list of all the drawings validated for a given MSN . It includes installation drawings , sorted by ATA sequence . Using keyword in the DNI enables to access directly to the right drawing section.

Drawing format is 2D TIF and JPG; some files may be in .pdf. 3D CAD models (Computer Aided Design) are not included in the contractual drawing set on WB/SA/LR. Specific Requirements for CAD Engineering data will be handled on a case-by-case , in line with specific Airbus contractual and commercial agreements.

Contact: drawing.service@airbus.com